3D Printed Tools For Portable Antennas

3D PRINTED TOOLS FOR PORTABLE ANTENNAS

by Dennis Gregory (WU6X)

Last month I discussed a few cool tools for the workbench: a wire-splicing vise and a solder spool caddy, as well as a guy line tensioner called the Loop Alien. I also mentioned another tensioner that is quick and easy to use, called the Seahorse. This article will discuss the Seahorse tensioner and its use for guying temporary masts, or other temporary antenna structures that you might use on a POTA or SOTA expedition, or in your backyard.

For example, let’s say you are using a push-up mast to hold the center (feedpoint) of an inverted-V or one end of a long wire antenna. A minimum of three guys is likely required, and will typically consist of strong twine or guy line of an appropriate diameter. The Seahorse tensioner can be 3D printed in any size and, therefore, can be used on most applications where guys are needed and be easily adjusted.

With a little imagination, you can see why this tensioning device is called a “seahorse”. Now, let’s walk through a practical application: using it to take up slack and hold a guy line. I’ll post a couple of links to videos showing this device in action later in this article.

THE STEPS
1. Let’s assume you have the high end of the guy line attached to a guy ring or another way to secure the line to the top of the mast.

2. Next, pass the loose end, the far end near the “anchor” point, around the anchor (tree, tent stake, sturdy limb of a bush at ground-level, eye-bolt stake, etc.).

3. Feed the loose end, from around or through the anchor point, through the hole in the Seahorse and tie an overhand knot to secure it.

4. Pull the slack out of the guy line and pass it through the first notch in the Seahorse.

5. Next, pass the guy line through the 2nd notch in the Seahorse. At this point, you can pull or release tension, as the Seahorse will hold the line at the desired tension.

6. For a more secure application, make one turn around the Seahorse before passing it through the 2nd notch.

And that’s all there is to it … This is one of the simpler but most effective guy tensioners on the market. You can 3D print them using PETG filament for added strength, or purchase them on Amazon or through an outdoor store like Big 5.

I hope this article helps you secure your antenna guy line, or tent-to-stake guy, with less angst, as most people I come across are fairly “knot-challenged”. If you fall into that category, the Seahorse may be just the answer for trouble-free remote ops or camping applications.

The links to buy, view a video, or 3D print the Seahorse follow.
Video1: https://www.youtube.com/watch?v=z1LJLPXbdYY
Video2: https://www.youtube.com/watch?v=wbh1ICYGB1Y
3D Print File: Makerworld Print File